28 FEBRUARY 1986
LOADER, SCOOP TYPE, DED, 4X4,
ARTICULATED FRAME STEER, 2-1/2 CUBIC YARD
(J.I. CASE MODEL MW24C)
Reference: TM 5-3805-262-10, TM 5-3805-262-20, C9100-IL, and TB 43-0210.
C l e a n fittings before Iubricating. Clean parts.
I n t e r v a l s (on-condition or hard time) and the
with dry cleaning solvent (SD), Type II or
related man-hour times are based on
normal operation. The man-hour time speci-
equivalent. Dry before lubricating. Dashed
f i e d is the time you need to do all the serv-
arrow points indicate lubrication on both
i c e s prescribed for a particular interval. On-
sides of the equipment.
condition (OC) oil sample intervals shall be
applied unless changed by the Army Oil
The lowest level of maintenance authorize
Analysis Program (AOAP) laboratory.
to lubricate a point is indicated by one of the
Change the hard time interval if your lubri-
following symbols as appropriate: Oper-
c a n t s are contaminated or if you are operat-
ator/crew (C); and Organizational Mainte-
ing the equipment under adverse operating
n a n c e (O).
o p e r a t i n g hours. The hard time interval may
Reporting Errors and Recommending
be extended during periods of low activity.
Improvements. You can help improve this
If extended, adequate preservation precau-
manual. If you find any mistakes or if you
t i o n s must be taken. Hard time intervals will
know of a way to improve the procdures,
be applied in the event AOAP laboratory
please let us know. Mail your letter or DA
support is not available.
Form 2028 (Recommended Changes to
Publications and Blank forms) direct to
Commander, US Army Tank-Automotive
Command, ATTN: AMSTA-MB, Warren
D r y cleaning fluid is flammable. Do not use
near a flame or excessive heat. Use only with
breathing of vapors and minimize skin
* The time specified is the time required to perform all services at the
p a r t i c u l a r interval (on-condition or hard times).
CARD 1 OF 6