OPERATOR CONTROLS CONTINUED
COMPONENT OR INDICATOR
Bucket Control Lever
The bucket control lever is the left lever to the right of
the operator's seat. This lever controls the roll back and
dump operations of the bucket. Refer to Loading
Mechanism Operation in WP 0005 for additional
Depress this pedal to increase engine speed; release
the pedal to decrease engine speed.
Depress the brake pedal according to the loader's
speed and the road conditions when slowly release the
pedal as the loader's speed decreases. When the
loader comes to a complete stop, there should only be
enough pressure to hold it stationary.
Brake and Transmission
This pedal works in the same manner as the brake
pedal except that it also stops clutch pressure in the
transmission. When this pedal is depressed no power
can be transmitted thorough the transmission and full
engine power can be used to operate the loader hydrau-
lics while braking.
Horn button is located on floorboard to left of brake and
transmission disconnect pedal. Step on button to sound
For operator's convenience in reaching the controls and
improved operating visibility, the operator's seat can be
adjusted to various positions.
Do not adjust the seat position while the loader
is in motion.
The height can be adjusted by removing the two height
adjustment bolts that secure the inner posts to the outer
post and lining up the holes in both posts at a high or
lower setting. Be sure to replace the two bolts with the
heads of the bolts towards the front of the seat.
To adjust the seat forward or backward, pull the slide
release lever under the seat to the left and slide the seat
to the desired position: then release the lever. The
height can be adjusted by removing the two bolts from
both sides of the seat base and lining up the holes at a
higher or lower setting: then reinstalling the bolts. The
seat is hinged to the base and can be tilted all the way
forward. Pull the tilt release chain at the lower front of
the seat to release the latch that is securing the seat.