STOPPING THE LOADER
1. Fully release accelerator pedal (Figure 9, Item 3).
Figure 9. Stopping the Loader.
Do not use the brake and transmission disconnect pedal when traveling at a fast speed or
when going downhill.
Do not fan the brakes by repeatedly depressing and releasing the brake pedal. This can
reduce air pressure too low for braking.
Failure to comply could cause damage to equipment.
2. Apply brake pedal (Figure 9, Item 4) or brake and transmission disconnect pedal (Figure 9, Item 5) until loader
comes to a complete stop.
3. Move transmission direction lever (Figure 9, Item 1) to neutral position (N).
Transmission can remain in gear if loader is brought to a temporary stop and operator
does not leave operator's compartment.
4. Lower bucket to ground.
5. Apply parking brake (Figure 9, Item 2).