CLEANING AND INSPECTION
Clean and inspect all parts IAW General Maintenance Instructions (WP 0019).
Parts that are to be assembled immediately should be dipped in light oil to prevent
corrosion. If any parts are to be stored for any length of time, they should be coated with a
good grade rust preventive and wrapped in paper treated to prevent corrosion.
a. Inspect transfer drive shaft for signs of wear or ridging. Replace if necessary.
b. Inspect transfer drive housing for wear or damage. Replace if necessary.
END OF TASK
Ensure cups are seated securely against housing shoulders.
1. Install output bearing cup (Figure 9, Item 2) and input bearing cup (Figure 9, Item 1) in housing (Figure 9, Item
Figure 9. Bearing Cups Installation.