DISASSEMBLY AND ASSEMBLY
REMOVE NO-SPIN DIFFERENTIAL 3258-D-11
a) remove rear axle housing front support
b) remove axles (rear)
1. Remove bolts (1) that hold the differential to
the axle housing.
2. Fasten tool (A) to differential (3) and remove it
from the axle housing. The weight of the differ-
ential is 150 kg (330 lb.).
NOTE: Two ½-13 NC forcing screws (27) can be
used to loosen differential (3) from the axle housing.
3. Remove O-ring seal (4) from the differential.
INSTALL NO-SPIN DIFFERENTIAL 3258-D-12
Make sure the O-ring seal is installed around
the differential and put clean oil on it.
Fasten tool (A) and a hoist to differential (1) as
Put differential (1) in position in the outer
hand wheel assembly.
housing with the bevel gear toward the right
Install bolts (2) and tighten them to a torque of
270 ± 25 N-m (200 ± 18 lb. ft.).
a) install rear axle housing front support
b) install axles (rear)