DISASSEMBLY AND ASSEMBLY
Install ring (25) on carrier (26).
Install carrier (26) in carrier (23).
Make an alignment of the gear on the shaft and
carrier and carrier (23) with gear (15).
Install carrier (23) in the No. 1 clutch housing.
Install date (27) in the No. 1 clutch housing so
the smAll hole in the plate is in alignment with
small hole (29) in the housing.
22. Install four discs (28) and three plates (30)
(reverse) in the No. 1 clutch housing. Start and
stop with a disc.
23. Put plate (31) in position on the No. 1 clutch
housing as shown. For models 950BNSCE and
950BSCE only, install disk (138) on No. 1 car-
rier with smaller diameter up.