DISASSEMBLY AND ASSEMBLY
TILT LINK AND LEVER
Install tooling (B) on the pin as shown.
Fasten a hoist to tooling (B) so the tooling will
not fall when the pin is removed.
Remove the pin with tooling (B). The weight of
the pin is 34 kg (75 lb.).
Remove the lever and link assembly. The
weight of the lever and link assembly is 338 kg
Remove bolt (14), the washer and spacer that
holds pin (13) in place.
Install tooling (A) on pin (13) and remove the
Remove the link from the lever,
Remove lip type seals (15) from both sides and
each end of link (17).
Remove bearings (16) from each end of link