DISASSEMBLY AND ASSEMBLY
Put brake assembly (10) in position in the ma-
8. Put the spring washer and link (11) in position
on the shaft of the cam. Tighten the bolt that
holds the link in position.
Install bolts (12) that hold the brake assembly
to the machine.
Put yoke (13) in position. Make an alignment
of the splines in the yoke with the splines on the
front drive shaft.
Install O-ring seal (14), plate (15) and the bolt.
Tighten bolt to 135 ± 15 N-m (100 ± 11 lb.ft).