DISASSEMBLY AND ASSEMBLY
ASSEMBLE FAN DRIVE
1. Install pulley (1) on hub (2) as shown.
NOTE: The pulley must be installed on the hub with
the spacer down against the shoulder of the hub.
Install the bearing in the hub.
Use tooling (A) to install lip type seal (4) in the
hub with the lip of the seal up. The top of the
seal must be even with the end of the hub.
Put 5P960 Multipurpose Type Grease on the
lip of the seal.
Install spacer (3) in seal (4).
NOTE: Make sure mounting bolts (7) are put in
position before the pulley and hub are installed on
6. Put pulley and hub assembly (5) on shaft as-