REMOVAL (SHEET 4 OF 5)
TM 5-3805-262-20
B e f o r e p e r f o r m i n g f o l l o w i n g s t e p , c h e c k a n d e n s u r e t h a t a l l h y d r a u l ic
hoses and wiring will not interfere with removal of bucket tilt cylinder
a s s e m b l y . F a i l u r e t o d o s o c o u l d c a u s e s e r i o u s i n j u r y d u e t o c y l i n d e r
assembly falling on you. If you are
medical assistance immediately.
( 1 0 ) P u l l b u c k e t t i l t c y l i n d e r a s-
sembly from pivot shaft and
lower to ground. Remove chain
hoist nylon straps from around
cylinder assembly.
NOTE
Repeat steps (1) through (10)
a b o v e t o r e m o v e r e m a i n i n g
cylinder assembly.
P e r f o r m f o l l o w i n g s t e p s o n ly
if these parts are not already
i n s t a l l e d o n r e p l a c e m e n t
cylinder assembly.
(11) Cut, remove, and discard clamp
( 1 1 ).
injured by falling equipment, obtain
(12) Identify and tag tube (12). Loosen tube fitting and remove tube. Remove
saddle (13).
(13) Remove elbow (14) and 0-ring (15). Discard 0-ring.
11-7