Remove cotter pin (1) .
Remove clevis pin (2), pull actuating rod (3) from clamps (7), and withdraw
from guide rod (11).
Loosen and remove two nuts (4), lock washers (5), and capscrews (6). Remove
two clamps (7) from cylinder assembly rod end.
Loosen and remove two nuts (8), lock washers (9), and capscrews (10).
Remove guide rod (11) by opening straps (12) and disengaging slots in guide
rod welded brackets from tabs on straps.
Remove two straps (12) from cylinder assembly by spreading straps and pulling,
from cylinder assembly.