Loosen and remove nut (1) and disconnect wire (6) terminal from back-up
a l a r m .
Loosen and remove nut (2) and disconnect wiring harness black-red wire
terminal (3) from back-up alarm.
Loosen and remove two nuts (4) and lock washers (5); disconnect wire (6)
terminal from capscrew (8) and remove wire (6).
Remove two washers (7), capscrews (8), and washers (9) then remove backup
At right side of transmission, at control valve, disconnect wiring har-
ness violet-red wire spade terminal (11) from spade terminal (12) by
grasping both with fingers and firmly pulling apart.
Disconnect wiring harness black-red wire spade terminal (13) from spade
t e r m i n a l ( 1 4 ).
Loosen and remove back-up alarm switch (15) using open end wrench.