3-30. ENGINE TROUBLESHOOTING (CONT)
TEST OR INSPECTION
6. ENGINE STALLS FREQUENTLY OR DOES NOT DEVELOP FULL POWER (Cont).
S t e p 7 . ( C o n t ) .
Watch VTM display and idle engine.
VTM display should be 700 to 750 rpm.
Watch VTM display and depress accelerator pedal until maximum gov-
erned speed of 2300 to 2340 rpm is displayed.
Press further on accelerator pedal.
Check that VTM display is within 2300 to 2340 rpm.
Idle engine for three minutes then turn off engine.
a. If engine rpm is not as specified above, check adjustment of ac-
c e l e r a t o r l i n k a g e ( p a g e 4 - 6 4 ) ; a d j u s t i f n e c e s s a r y . I f a d j u s t-
ment is okay, notify next higher maintenance level to adjust
fuel injection pump.
b. If engine rpm is as specified above, go to step 8 below.
If VID has not been entered in VTM, dial 60 into TEST SELECT and
press and release TEST. When UEH appears on VTM display, dial 22
into TEST SELECT and press and release TEST.
Perform compression unbalance test:
Be sure batteries are at full charge. Dont do more than two compression
unbalance tests in a row as loader batteries may discharge.
Check that fuel SHUT OFF control is pulled completely out.
Crank engine for five seconds to clear fuel from cylinders.
Set VTM TEST SELECT switches to 14.
While cranking engine with bad or discharged batteries, VTM may lose
power and come on again after cranking has stopped, displaying -----. If
this happens, clean battery posts and clamps and try again. If VTM still
loses power, connect VTM to another vehicles battery. Connect P1 of
test probe cable W2 to J4 of VTM and W2 black test clip to loader bat-
t e r y n e g a t i v e p o s t a n d r e d t e s t c l i p t o l o a d e r b a t t e r y p o s i t i v e p o s t.
Then set VTM TEST SELECT switches to 15.
Press and release TEST.
When GO appears on display, crank engine until OFF or E013 appears
on display. Be sure to return ignition key switch to off position .
Display should indicate (TBD).