INSTALLATION (SHEET 2 OF 2)
Position two hose clamps on body assembly to water manifold hose and
install hose on body assembly (11) and water manifold as shown below.
Position hose clamps on ends of hose and tighten hose clamps.
Install elbow in water pump port. Position hose clamp on oil cooler hose.
Install oil cooler hose on elbow,
hose, and tighten hose clamp.
position clamp on end of oil cooler
Position new gasket (7) on body assembly (11) and install water pump
assembly (6); secure using four lock washers (5) and nuts (4). Tighten
nuts to 35 to 42 lb - ft.
Position pulley (3) on water pump assembly (6) and secure using washer
(2) and capscrew (1).
Connect heater hose to valve (14) (page 10-43).
Install fan assembly (page 4-101) .
I n s t a l l d r i v e b e l t s ( p a g e 5 - 5 ) .
Fill radiator with coolant (page 4-71) and check for coolant leaks.