Install tachometer and hourmeter (8) using clamp (7), two lock washers
(6) and two nuts (5). Tighten nuts evenly.
Install cover (3) over tachometer and hourmeter (8) using four spacers
(4) and screws (2). Tighten screws evenly.
Lubricate cable (1) using grease at female end while turning male end
w i t h f i n g e r s .
From top of loader, route male end of cable (1) between engine block and
manifold to tachometer drive.
Connect female end of cable (1) to tachometer and hourmeter (8) and
tighten cable nut using pliers.
Connect male end of cable (1) to tachometer drive and tighten cable nut
u s i n g p l i e r s .
Install engine top hood (page 9-13).
I n s t a l l e n g i n e l e f t f r o n t s i d e p a n e l ( p a g e 9 - 1 7 ).