4-3. TRANSMISSION MAINTENANCE (CONT)
a. Transmission Torque Converter Group
(Cont ) .
DISASSEMBLY (SHEET 1 OF 3)
(1) Find alinement marks on turbine housing (21) and turbine
ment marks cannot be seen, use hammer and punch and mark
(16). If aline-
Use hammer and punch to drive six turbine pins (15) inward toward hub
until they clear the holes in turbine housing (21).
Remove turbine (16) from turbine housing (21).
Remove turbine assembly (17) with bearing (18) installed as an assembly
from turbine housing (21).
Put turbine housing (21) on
wood blocks as shown. Using
hammer and punch, push bearing
(20) from hub using bearing re-
moval holes in turbine housing.
Using retaining ring pliers,
remove retaining ring (19) from
turbine assembly (17).