REMOVAL (SHEET 2 OF 2)
(b) Loosen tachometer drive cable nut using pliers and pull cable end
(c) Install tachometer drive removal
tool on tachometer drive threads.
(d) Turn tachometer drive removal
tool nut clockwise using open end
wrench until tachometer drive is
pulled from cylinder block bore.
(e) Separate tachometer drive removal
tool from tachometer drive
threads by turning counterclock-
CLEANING AND INSPECTION (SHEET 1 OF 2)
Dry cleaning solvent P-D-680 used to clean parts is toxic and flammable.
Wear protective goggles and gloves and use only in a well ventilated
area. Avoid contact with skin, eyes and clothes and donut breathe
vapors . Do not use near open flame or excessive heat and don-t smoke
when using it. Failure to do so could cause serious injury. If you be-
come dizzy while using cleaning solvent, get fresh air and medical
attention immediately-. If contact with skin
with large amounts of water. If contact with
with water and get medical aid immediately.
or clothes is made, flush
eyes is made, wash eyes