INSTALLATION (SHEET 4 OF 7)
(13) Install capscrew, clamp, lock washer, and nut to fasten clam cylinder
tube (23) to front chassis on left side of loader.
(14) Connect and tighten hose fitting (24) to clam cylinder tube (23).
(15) Connect and tighten tilt cylinder tube (22) to fitting installed in lower
middle port of control valve assembly. Tighten other end of tilt cylinder
18. Lift cylinder tube
19. Nuts (4)
20. Tube flanges
21. Inlet tube
(16) Connect and tighten inlet tube (21) to fitting installed in front port of
control valve assembly.
(17) Tighten four nuts (19) on tube flanges (20) to 34 to 45 lb-ft.
(18) Connect and tighten lift cylinder tube (18) between fitting installed in
lower rear port of control valve assembly and tee fitting at center of