TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
Table 2. Machine Control System - Continued.
TEST OR INSPECTION
CID FMI CODE
N OT E
This test procedure may create other diagnostic codes. Ignore these created diag-
nostic codes and clear these diagnostic codes when original diagnostic code has
been corrected. Ensure diagnostic code CID 1404 FMI 05 is active before per-
forming this procedure.
1. If diagnostic code remains active, go to
1. Check clutch 4 (second speed) solenoid.
(a) Turn battery disconnect switch and
engine start switch to ON position (TM 2. If diagnostic code is no longer active,
failed. Repeat this test to verify clutch
(b) Disconnect clutch 4 (second speed)
4 (second speed) solenoid failure.
Replace modulating valve (WP 0177
(c) At clutch 4 (second speed) solenoid
wiring harness connector, place a
jumper wire from contact 1 (wire 900
PU) to contact 2 (wire 975 WH).
observe status of CID 1404 FMI 05.