TRANSMISSION TESTS, INSPECTIONS, AND ADJUSTMENTS - CONTINUED
TRANSMISSION PRESSURES TEST AND ADJUSTMENT - CONTINUED
Torque Converter Inlet Pressure Test
N OT E
Pressure tap is located on transmission relief valve. Transmission relief valve is located below modulating
Remove right side covers to gain access (WP 0107
Install correct hose assembly from pressure gage on
pressure tap (13). Attach opposite end of hose assem-
bly to 0 to 290 psi (0 to 2,000 kPa) to pressure gage.
Start engine and operate engine at high idle (TM 5-3805-290-10). Observe pressure gage. With oil at normal operating
temperature, torque converter inlet pressure must be below values shown in Table 8.
Table 8. Transmission Torque Converter Inlet Pressure.
Torque converter inlet
(895 kPa) maximum