FRONT HOUSING REPLACEMENT - CONTINUED
CLEANING AND INSPECTION
WARN I N G
· Solvent cleaning compound MIL-PRF-680 Type III is an environmentally compliant and low-toxic mate-
rial. However, it may be irritating to the eyes and skin. Use protective gloves and goggles. Use in well-
ventilated areas. Keep away from open flames and other sources of ignition. Failure to do so may result
in injury or death to personnel.
· Particles blown by compressed air are hazardous. DO NOT exceed 15 psi (103 kPa) nozzle pressure
when drying parts with compressed air. DO NOT direct compressed air against human skin. Make sure
air stream is directed away from user and other personnel in the area. To prevent injury, user must wear
protective goggles or face shield. Failure to follow this warning may result in injury to personnel.
Clean all parts and mating surfaces with solvent cleaning compound.
Remove gasket material from mating surfaces.
Dry parts with compressed air.
Inspect all parts for wear, pitting, cracks, or corrosion and replace if necessary.
Inspect oil passages to ensure they are clean and unobstructed.
Inspect condition of gasket. Replace gasket if necessary.
N OT E
· Apply gasket sealant to bottom portion of gasket.
· Cut gasket to correct length if necessary.
Install new gasket (4) and front housing (2).