WARN I N G
Use caution when using adhesives and sealants. Prolonged inhalation of vapors can
cause lung irritation. Contact with skin can cause dermatitis. Wear gloves and safety
goggles and use product in a well-ventilated area away from open flame. If ingested, keep
individual calm and seek medical attention. DO NOT induce vomiting. If contact with skin
or eyes is made, flush thoroughly with water. Dispose of cleanup rags IAW local policy
and ordinances. Failure to follow this warning may result in injury to personnel.
1. Apply sealing compound to stud (Figure 1, Item 3) on chassis connection side only.
N OT E
Tighten pin until it bottoms out on threaded hole.
Tighten inner nut until the return latch slides with some resistance and holds position
unassisted. Do not overtighten. Tighten outer nut down onto inner nut to lock.
2. Install stud (Figure 1, Item 3), washer (Figure 1, Item 4), ROPS latch (Figure 1, Item 1), hook (Figure 1, Item 2),
special washer (Figure 1, Item 5), spring washer (Figure 1, Item 6), inner nut (Figure 1, Item 7), and outer nut
(Figure 1, Item 8) on machine.
END OF TASK
Verify correct operation of machine (TM 5-3805-292-10).
END OF TASK
END OF WORK PACKAGE