TRANSMISSION FILL CALIBRATION CONTINUED
19. Calibration may be unsuccessful for many reasons, and an error code (Figure 13, Item 1) will be generated. If
the error is related to calibration requirements, operate machine to meet calibration test setup conditions, and
perform calibration procedure again. If the error is related to an event or diagnostic code, repair the active
event or diagnostic code (WP 0005); then perform this calibration procedure. If any solenoid fails, perform this
calibration procedure again.
Figure 13. Calibrating Successful.
20. Turn ignition switch and battery disconnect switch to off position (TM 5-3805-298-10).
END OF TASK
END OF WORK PACKAGE