NOTES:
1.
FOR OPERATION OF EQUIPMENT IN PROTRACTED COLD TEMPERATURES BELOW- 10 . Remove lubricants prescribed in the key for
F
temperatures above - 10 . Relubricate with lubricants specified in the key for temperatures below - 10
F
F
2.
ENGINE OIL FILTERS. Every 100 hours remove filter elements, clean housings, install new elements, fill crankcase, operate engine for 5
minutes, check for leaks, check crankcase oil level and bring to full mark.
3.
HYDRAULIC RESERVOIR OIL FILTER. Every 250 hours remove filter element, clean housing, sediment trap, screen, and filler strainer. Install
new element, fill system, operate equipment for 5 minutes, check for leaks, check hydraulic oil level, and bring to full mark.
4.
OIL CAN POINTS. Every 50 hours lubricate throttle linkage, and all exposed adjusting threads with OK.
5.
LUBRICANTS. The following is a list of lubricants with the Military Symbols and applicable Specification numbers. OES MIL-L-10295 OE MIL-L-
2104 GO MIL-L-2105 GOS M IL-L-10324 H BA Ml L-H-139 10 GAA MIL G-10924
Copy of this Lubrication Order will remain with the equipment at all times; instructions contained herein are mandatory.
BY ORDER OF THE SECRETARY OF THE ARMY:
W. C. WESTMORELAND
General, United States Army
OFFICIAL:
Chief of Staff
KENNETH G. WICKHAM,
Major General, United States Army,
The Adjutant General.
LO 5-3805-201-12-1 DISTRIBUTION: To be distributed in accordance with DA Form 12-25, Section III, (qty rqr block no. 401) Operator maintenance requirements
for Earth Moving Equipment: Loaders.
*U.S. GOVERNMENT PRINTING OFFICE: 1985-461-06/20082
