TM 5-2420-231-23-1
0045
Table 1. Rear Taillights and/or Blackout Marker Lights Do Not Function Correctly - Continued.
045
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
5. Using a digital multimeter, mea-
Resistance 5.0 Ohms or Less - Install
Rear Taillights and/or
sure resistance between front con-
signal lights fuse (TM 5-2420-231-10).
Blackout Marker Lights Do
sole wiring harness connector (WP
Proceed to Test Step 21.
Not Function Correctly -
0007, Figure 71) terminal F and
Continued
Resistance Greater Than 5.0 Ohms -
front console wiring harness con-
Replace front console wiring harness
nector (WP 0007, Figure 70) termi-
(WP 0162).
nal 3C. Resistance should be 5.0
ohms or less.
Test Step 11. Check for Faulty Light
Control Switch.
1. Remove screw (Figure 2, Item 4)
and lever (Figure 2, Item 3) from
light control switch (Figure 2,
Item 5).
2. Remove four screws (Figure 2,
Item 1), washers (Figure 2,
Item 2), and light control switch
(Figure 2, Item 5) from bracket
(Figure 2, Item 6).
3. Install lever (Figure 2, Item 3) and
screw (Figure 2, Item 4) on light
control switch (Figure 2, Item 5).
4. Place light control switch in the
B.O. MARKER position (Figure 2,
Item 7) (TM 5-2420-231-10).
0045-8