FRONT AXLE HOUSING

TM-5-3805-258-24-2 Loader Scoop Type DED 4x4 Articulated Frame Steer 2 1/2 Cubic Yard Bucket (CCE) Airborne/Airmobile Sectionalized and Nonsectionalized Manual
Page Navigation
228

DISASSEMBLY AND ASSEMBLY TM 5-3805-258-24-2 ENGINE FRONT AXLE HOUSING REMOVE FRONT AXLE HOUSING 3260-C-11 Tools Needed A 8S7815 Pin 2 8S8048 Saddle 2 — 8S7630 Stand 2 8S7641 Tube 2 1. 2. 3. 4. start by: a) remove tires and rims (front) b) remove front drive shaft Lift the bucket and put tooling (A) in position under the lift arms as shown. This will permit access to the front axle bolts. Disconnect brake line (1) from the junction box as shown. Fasten straps (2) and hoist to front axle hous- ing (3) as shown. Remove nuts (4), the bolts and the washers. Carefully lower front axle housing from the machine. The weight of the axle housing is 953 kg (2100 lb.). INSTALL FRONT AXLE HOUSING 3260-C-12 Tools Needed A 8S7615 Pin 2 8S8048 Saddle 2 8S7630 Stand 2 8S7641 Tube 2 1. 2. 3. 4. 5. Fasten straps (1) and hoists to axle housing (2). Put axle housing (2) into position on the ma- chine as shown. Install the bolts, the washers and nuts (4) that hold the axle housing to the machine. Tighten the nuts to a torque of 275 ± 35 N·m (200 ± 26 lb. ft.). Connect brake line (3) to the junction box. Remove (bleed) the air from the brake system. Remove tooling (A). end by: a) install tires and rims (front) b) install front drive shaft 5-182

Privacy Statement
Press Release
Contact