1-2. MAINTENANCE FORMS, RECORDS, AND REPORTS

CHAPTER 1 INTRODUCTION - TM-5-3805-262-20_15

1-11. SPECIAL TOOLS, TMDE, AND SUPPORT EQUIPMENT

TM-5-3805-262-20 Loader Scoop Type DED 4x4 Articulated Frame Steer 2-1/2 Cubic Yard (J.I. Case Model MW24C) Manual
Page Navigation
2

TM 5-3805-262-20 1-2. MAINTENANCE FORMS, RECORDS, AND REPORTS Department of the Army forms and procedures used for equipment maintenance will be those prescribed by DA PAM 738-750, The Army Maintenance Management System (TAMMS). 1-3. DESTRUCTION OFARMYMATERIEL TOPREVENTENEMYUSE Refer to TM 750-244-6. 1-4. PREPARATION FOR STORAGE OR SHIPMENT Refer to TM 5-3805-262-10 for preparation for storage and page 2-13 of this manual for preparation for air transport instructions. 1-5. QUALITY ASSURANCE/QUALITY CONTROL Quality assurance and quality control shall be in accordance with MIL-STD-109 and MIL-M-38784. 1-6. OFFICIAL NAMESAND NOMENCLATURE The nomenclature, names, and designations used in this manual are in accordance with MIL-HDBK-63038-2 . 1-7. REPORTING EQUIPMENT IMPROVEMENT RECOMMENDATIONS (EIR) If your MW24C loader needs improvement, let us know. Send us an EIR. You, the user, are the only one who can tell us what you don-t like about your equipment. Let us know why you don’t like the design. Put it on an SF 368 (Quality Deficiency Report). Commander, US Army Tank-Automotive Command, Mail it to us at: ATTN: AMSTA-MV, Warren, MI 48397-5000. We’ll send you a reply. 1-8. WARRANTY INFORMATION The MW24C loader is warranted by J.I.Case Company, Racine, Wisconsin for 15 months or 1500 hours of operation, whichever occurs first. Warranty starts on the date found on DA Form 2408-9 in the logbook and/or the equipment warrenty data plate. Report all defects in material or workmanship to your supervisor who will take appropriate action. 1-9. ORIENTATION The loader bucket is mounted at the front of the MW24C and the engine faces the rear. Controls for operating the bucket (lift, tilt, clam) are located to the right when you are sitting in the operator-s seat. All references to right, left, front, or rear are from your viewpoint when you’re sitting in the operator’s seat. 1-10. COMMON TOOLS AND EQUIPMENT For authorized common tools and equipment refer to the Modified Table of Organiza- tion and Equipment (MTOE) applicable to your unit. 1-2

Privacy Statement
Press Release
Contact