TM 5-3805-262-20
REMOVAL (SHEET 2 OF 2)
(4)
( 5)
(6)
(7)
( 8)
( 9)
(10)
(11)
(12)
(13)
(14)
(15)
(16)
(17)
(18)
(19)
(20)
(21)
(22)
(23)
Loosen two clamps (4).
Loosen and remove two nuts (5), lock washers (6), and capscrews (7).
Disconnect hose (8) from HEAT CONTROL valve and tube (11) and remove it.
Remove clamps (4 and 9) from hose (8).
Loosen clamps (10 and 12).
Remove clamps (10 and 12).
Loosen two clamps (14) and
Loosen and remove two nuts
Disconnect and remove tube (11) and hose (13).
clamp (16).
(17), lock washers (18), and capscrews (19).
Disconnect hose (30) from tube (20). Then, disconnect and remove tube
(20) from hose (15). Remove clamps (21) from tube.
Disconnect hose (15) from HEAT CONTROL valve then remove two clamps (14)
and clamp (16).
Loosen clamp (22) at bottom of heater core.
Disconnect hose (33) from heater core tube and remove clamp (22).
At engine, loosen two clamps (23) and disconnect hoses (30 and 33).
Loosen and remove three nuts (24), lock washers (25), and capscrews (26);
remove three clamps (27) and two spacers (28).
Cut, remove and discard three tie straps (29).
Remove hose (30) from loader.
Loosen and remove nut (31); remove clamp (32) from around hose (33).
Remove hose (33) from loader.
While assistant in cab holds capscrews (37) using socket wrench, loosen
and remove four nuts (34), lock washers (35), and washers (36) from
b e n e a t h f l o o r p l a t e.
Remove four capscrews (37) and heater console (38).
If necessary, remove two capscrews (40) and lock washers (39); remove
b r a c k e t ( 4 1 ).
10-39
