TM 5-3805-291-23-2
ENGINE ELECTRONIC CONTROL MODULE (ECM) REPLACEMENT - CONTINUED
0057 00
COPY CONFIGURATION (PROGRAM ECM) - CONTINUED
N OT E
As the data is loading to the ECM, the "Testing ECM..." message displays. You may cancel the process at
any time by pressing the "Cancel" push-button. The "Are you sure..." dialogue box is displayed. Press
"Yes" to cancel loading the data or "No" not to cancel.
6.
If the "The following parameters cannot be programmed..." message appears, select "OK".
7.
Close the "The Programming complete..." dialogue box by selecting "OK".
8.
The "The following parameters cannot be programmed..." message will reappear. Then select "OK".
9.
Start engine. Run until operating temperature is reached and verify proper operation of all components (TM 5-3805-
291-10). Check for active diagnostic codes by selecting "Active Diagnostic Codes" from the "Diagnostics" menu (WP
0006 00).
10.
Disconnect ET (WP 0005 00).
Table 2. Engine ECM Replacement.
PARAMETER
VALUE
Engine Fan Control
ON
Low System Battery Voltage Elevated
Enabled
Ether Solenoid Configuration
Continuous Flow Solenoid
Engine Fan Reversing Feature
Disabled
Engine Warm-Up Elevated Idle Feature Enable Status
Enabled
Machine Working Engine Low Idle Speed Configuration
950.0 rpm
Machine Hibernating Engine Low Idle Speed Configuration
6,000.0 rpm
END OF WORK PACKAGE
0057 00-7/(0057 00-8 Blank)
