TM 5-3805-291-23-2
REMOTE LUBRICATION LINES, HOSES, AND FITTINGS REPLACEMENT - CONTINUED
0129 00
CLEANING AND INSPECTION
WARN I N G
Solvent cleaning compound MIL-PRF-680 Type III is an environmentally compliant and low-toxic
material. However, it may be irritating to the eyes and skin. Use protective gloves and goggles. Use in
well-ventilated areas. Keep away from open flames and other sources of ignition. Failure to do so may
result in injury or death to personnel.
Particles blown by compressed air are hazardous. DO NOT exceed 15 psi (103 kPa) nozzle pressure
when drying parts with compressed air. DO NOT direct compressed air against human skin. Make
sure air stream is directed away from user and other personnel in the area. To prevent injury, user
must wear protective goggles or face shield. Failure to follow this warning may result in injury to per-
sonnel.
1.
Clean all parts and surfaces with solvent cleaning compound.
2.
Dry parts with compressed air.
3.
Inspect all parts for damage, wear, pitting, cracks, or corrosion and replace if necessary.
INSTALLATION
1.
Position hose (80) on machine and connect to steering cylinder (81).
2.
Install connector (79) on hose (80).
3.
Connect line (62) to connector (79).
4.
Install clamp (78), spacer (77), clamp (76), washer (75), and bolt (74) on machine.
5.
Connect line (72) to mid-bearing (73).
6.
Install union (71) on line (72).
7.
Connect line (61) to union (71).
8.
Install connector (69) on trunnion (70).
9.
Connect line (60) to connector (69).
10.
Install four clips (68) on lines (60, 61, and 62).
11.
Install four clips (68), three washers (67), and nuts (66) on machine.
0129 00-11