TM 5-3805-291-23-2
HYDRAULIC SYSTEM OIL CHANGE AND FILTER REPLACEMENT - CONTINUED
0148 00
FILL AND FILTER INSTALLATION - CONTINUED
4.
Install hydraulic filler cap (3) on machine.
5.
Run engine for a minimum of 10 seconds. Stop engine and check hydraulic oil level. If necessary, remove hydraulic
filler cap (3) and add clean oil until "FULL" mark on sight gage (10) is reached. Install hydraulic filler cap on machine.
6.
Run engine at low idle and cycle work tool so all hydraulic systems are filled with oil. Check oil level. If necessary,
remove hydraulic filler cap (3) and add oil until "FULL" mark on sight gage (10) is reached. Stop engine and check oil
level and add oil if necessary. Check for leaks.
7.
Install strainer and retaining ring in hydraulic filler cap (3).
8.
Install hydraulic filler cap (3) and padlock (2) on machine.
427-C0216
9.
Close access door and install two washers (5) and
bolts (4).
427-C0213
END OF WORK PACKAGE
0148 00-5/(0148 00-6 Blank)