TM 5-3805-298-23-1
0046
Table 1. 5 Fuel Injector 5 Diagnostic Codes - Continued.
046
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
5-6 Fuel Injector 5 Current
Test Step 1. Check for Active
Above Normal - Continued
Diagnostic Codes.
1. Connect MSD and select C6.6 924
2. Start engine or attempt to start
Diagnostic Code 5-6 Active - Proceed
engine (TM 5-3805-298-10) while
to Test Step 2.
using MSD to check for active
Diagnostic Code 5-6 Not Active -
Troubleshooting is complete.
Test Step 2. Isolate Fault.
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-298-10).
2. Disconnect connector E-C15
Figure 8).
3. Turn battery disconnect switch and
ignition switch to ON position
(TM 5-3805-298-10).
NOTE
The fuel injector solenoid test will activate the injector for each cylinder
until the stop button on ET is selected. The results screen will display
"OK" for each injector before testing, and when the injector test does not
find a fault. The results screen will display "Testing" while the injector is
activated. After each injector is tested the results screen will display "Not
OK (*Open)" or "Not OK (*Short)."
Cylinder 5 Test Results Display Not
(WP 0163) to activate fuel
OK (*Open) - Proceed to Test Step 2.
injectors.
Cylinder 5 Test Results Display Not
OK (*Short) - Proceed to Test Step 3.
Test Step 3. Test for Shorted Injector
Cylinder 5 and 6 Jumper Harness.
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-298-10).
2. Remove valve cover (WP 0187).
3. Disconnect two wires 1 and 2
injector 5 (WP 0198).
0046-8