TM 5-3805-298-23-1
0073
Table 1. Transmission Does Not Operate in First Gear, Forward or Reverse - Continued.
073
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
7. Visually inspect transmission oil
Transmission Oil Cooler Hoses Are
Transmission Does Not
Not Leaking - Drain and fill transmis-
cooler hoses for Class III leaks
Operate in First Gear,
sion oil (WP 0312).
(WP 0173). Check the ground for
Forward or Reverse -
signs of leakage.
Continued
Proceed to Test Step 6.
Transmission Oil Cooler Hoses Are
Leaking - Tighten or replace transmis-
sion oil cooler hoses
(WP 0173).
Proceed to Test Step 6.
Test Step 4. Perform Transmission
Clutch Calibration.
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-298-10).
2. Perform transmission clutch fill
Transmission Fill Calibration
calibration (WP 0167).
Succeeded - Proceed to Test Step 5.
Transmission Fill Calibration Failed
- Perform the transmission clutch fill
calibration procedure (WP 0167)
again. If transmission fill calibration
fails replace transmission clutch 6
solenoid valve (WP 0310).
Proceed to Test Step 6.
Test Step 5. Check Clutch 6 Oil
Pressure.
1. Apply sealant on threads of 580
psi (4,000 kPa) gauge (Figure 1,
Item 1) and a 6V-3966 valved
nipple (Figure 1, Item 3) from
pressure gauge kit.
2. Install adapter (Figure 1, Item 4)
on 580 psi (4,000 kPa) gauge
(Figure 1, Item 1).
3. Install 6V-3966 valved nipple
(Figure 1, Item 3) on adapter
(Figure 1, Item 4).
4. Connect hose 177-7861 (Figure 1,
Item 2), from pressure gauge kit, to
6V-3966 valved nipple (Figure 1,
Item 3).
0073-4