TM 5-3805-298-23-1
0128
Table 1. Rear Right Turn Signal/Stoplight Does Not Operate - Continued.
0128
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
3. Disconnect connector M-C1
Rear Right Turn Signal/
(WP 0012, Figure 57) from
Stoplight Does Not Operate
connector C-C20 (WP 0012,
(Continued)
Figure 56).
4. Connect jumper wire between
M-C9 (WP 0012, Figure 158)
terminal 1 and M-C13 (WP 0012,
Figure 158) terminal 1.
5. Using digital multimeter
Resistance 5.0 Ohms or Less
(WP 0174), measure resistance
Replace lower cab wiring harness
between connector M-C1
(WP 0291).
(WP 0012, Figure 57) terminal 15
Proceed to Test Step 3.
and ground.
Resistance Greater Than 5.0 Ohms
Replace rear frame wiring harness
(WP 0295).
Proceed to Test Step 3.
Test Step 3. Verify Malfunction Is
Resolved.
1. Ensure all harness connectors are
connected.
2. Install right lower cab access
panels (WP 0347).
3. Install rear tail and backup light
housing (WP 0272).
4. Turn battery disconnect switch and
ignition switch to ON position
(TM 5-3805-298-10).
5. Turn the military light switch to Ser.
Drive position and lower switch in
OFF (TM 5-3805-298-10).
6. Turn the turn signal switch to right
turn signal position (TM 5-3805-
298-10).
7. Observe operation of rear right
Rear Right Turn Signal/Stoplight
turn signal (TM 5-3805-298-10).
Operates Troubleshooting complete.
Rear Right Turn Signal/Stoplight
Does Not Operate Repeat
troubleshooting from the beginning.
END OF WORK PACKAGE
0128-3/(4 blank)