TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
Table 2. Machine Control System - Continued.
TEST OR INSPECTION
CID FMI CODE
N OT E
This test procedure may create other diagnostic codes. Ignore these diagnostic
codes and clear diagnostic codes when original diagnostic code has been cor-
rected. Ensure diagnostic code CID 0368 FMI 04 is active before performing this
1. Check switch ground circuit in harness.
(a) Turn engine start switch and battery
to Test 2.
disconnect switch to OFF position (TM 2. If resistance is greater than 5,000
Ohms, circuit is open. Replace wiring
(b) Disconnect wiring harness
harness in question (WP 0169 00 thru
connector(s) from machine ECM (WP
WP 0175 00).
J1-13 (wire 202 BK) of ECM wiring
harness and contacts 2 and 5 (wire 202
BK) of switch.