EXPECTED TEMPERATURES
LUBRICANTS
CAPACITY
Above +32F
+40F to -10F
0F to -65F
INTERVALS
OE-OIL, Engine, Heavy Duty
OE 10
OE 10
Oil Can Points
OES
Transmission and Converter
21 qt
OES-OIL, Engine, Sub-zero
GO-LUBRICATING OIL, Gear
Intervals
Front Axle Planetary
2-5/8 qt ea
given are
GO 140
GO 90
GOS
Rear Axle Planetary
2-5/8 qt ea
in hours
Front Differential
22-1/2 qt
of normal
Rear Differential
20-1/2 qt
operation.
GOS-LUBRICATING OIL, Gear, Sub-zero
GAA-GREASE, Automotive and Artillery
ALL TEMPERATURES
NOTES:
1
.FOR OPERATION OF EQUIPMENT IN PROTRACTED COLD TEMPERATURES BELOW -10 . Remove lubricants prescribed in the key for
F
temperatures above 10 . Relubricate with lubricants specified in the key for temperatures below - 10-F
F
.
2.
OIL CAN POINTS. Every 50 hours lubricate handbrake, control lever linkage, and all exposed adjusting threads with OE.
3.
AXLE PLANETARIES. Every 50 hours rotate wheels until oil level line is horizontal. Check level. Every 1000 hours rotate wheels until drain and
fill plug is at bottom center, remove plug, and drain. To fill, rotate wheels until oil level is horizontal. and fill to plug opening.
4.
TRANSMISSION AND CONVERTER OIL FILTER. Every 500 hours remove filter element, clean housing, install new element, fill system,
operate equipment for 5 minutes, check for leaks. Check transmission oil level and bring to full mark.
5.
LOWER UNIVERSAL JOINTS AND SPLINES. Every 500 hours remove plugs from splines, install fitting, lubricate sparingly, remove fitting. and
install plugs.
6.
TRANSMISSION AND CONVERTER. Every 10 hours check transmission oil level with engine running at idle speed parking brake applied and
forward - reverse control lever in neutral. Every 1000 hours open vent cock on top of oil cooler, drain transmission, converter and oil cooler. Clean
breather and magnetic drain plugs. Fill transmission with OE-10 OIL to proper level. With oil cooler vent cock open run engine at idle speed for 2
minutes with parking brake applied, forward-reverse control lever in neutral position, close vent cock when a steady stream of oil appears. Check oil
level and bring to full mark.
7.
LUBRICANTS: The following is a list of lubricants with the Military Symbols and the applicable specification numbers.
OE MIL-L-2104
GO MIL-L-2105
GOS MIL-L-10324
OES MIL-L-10295
GAA MIL-G-10924
FOLD
FOLD
Copy of this Lubrication Order will remain with the equipment at all times; instructions contained herein are mandatory
BY ORDER OF THE SECRETARY OF THE ARMY:
W. C. WESTMORELAND
General, United States Army,
Chief of Staff.
OFFICIAL:
KENNETH G. WICKHAM
Major General, United States Army,
The Adjutant General.
LO 5-3805-201-12-2 DISTRIBUTION: To be distributed in accordance with DA Form 12-25, Section II (qty rqr block no. 401: Operator maintenance requirements for
Earth Moving Equipment: Loaders.
U.S. GOVERNMENT PRINTING OFFICE 829-10*U.S. GOVERNMENT PRINTING OFFICE: 1991 - 281-481 (40045) : QL 3
