NOTES - CONTINUED:
" F U L L " mark. Operate for 5 minutes,
c h e c k filter housing for leaks. When
AOAP laboratory support is not available,
i n s t a l l new filter element each 1000
hours.
9. HYDRAULIC RESERVOIR FILTERS.
E a c h 1000 hours, remove covers and
filters, clean filters and housings. Install
f i l t e r s and covers. After replacement,
operate hydraulic system for 5 minutes,
c h e c k for leaks, check level and bring to
"FULL" mark.
10. FRONT DIFFERENTIAL/REAR DIF-
F E R E N T I A L . Check level each 50 hours.
Change gear lubricant only when required
by maintenance repair action, contamina-
tion by water, or other foreign material.
After refill, operate for 5 minutes, check
for leaks and bring oil level to level plug
opening.
1 1 . FRONT PLANETARY HUB/REAR
PLANETARY HUB. Check level each 50
hours. Change gear lubricant only when
required by maintenance repair action,
contamination by water, or other foreign
m a t e r i a l . After refill, operate for five
minutes, check for leaks and bring oil
Copy of this Lubrication Order will remain
level to level plug opening.
with the equipment at all times, instruc-
tions contained herein are mandatory.
12. STEERING GEAR HOUSING. The fill
a n d level plug is located on the floor
By order of the Secretary of the Army:
board beside the steering column.
JOHN A. WICKHAM, JR.
13. LUBRICANTS. The following is a list
General, United States Army
of lubricants with military symbols and
Chief of Staff
applicable specification numbers.
OFFICIAL:
MIL-L-2104
OE/HDO
MIL-L-2105
GO
ROBERT M. JOYCE
MIL-G-10924
GAA
Major General, United States Army
MIL-L-46167
OEA
The Adjutant General
MIL-B-46176
BFS
P-D-680
(SD), Type II
DISTRIBUTION:
To be distributed in accordance with
DA Form 12-25B, Operator and Organi-
zational maintenance requirements for
Scoop Type Loader.
A219617
LO 5-3805-250-12
CARD 7 OF 7
