TM 5-2420-231-23-1
0051
Table 1. Transmission Does Not Shift into Forward - Continued.
051
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Transmission Does Not Shift
Test Step 31. Test Shift Lever
into Forward - Continued
Forward Voltage Supply Circuit for
Voltage.
1. Turn ignition switch to the off posi-
tion (TM 5-2420-231-10) and dis-
connect batteries (WP 0157).
2. Disconnect powershift controller
wiring harness connector (WP
0007, Figure 21) from powershift
3. Connect batteries (WP 0157) and
turn ignition switch to the on posi-
tion (TM 5-2420-231-10).
Voltage 10 to 14 Volts - Proceed to
sure voltage between front console
Test Step 32.
wiring harness connector (WP
No Voltage - Replace powershift lever
0007, Figure 185) terminal 85 and
(WP 0165).
machine ground. There should be
Proceed to Test Step 38.
no voltage.
Test Step 32. Test Front Console
Wiring Harness Forward Relay
Voltage Supply Circuit.
1. Turn ignition switch to the off posi-
tion (TM 5-2420-231-10) and dis-
connect batteries (WP 0157).
2. Disconnect powershift wiring har-
113) from front console wiring har-
112).
continuity between front console
wiring harness (WP 0162).
wiring harness connector (WP
Proceed to Test Step 38.
0007, Figure 112) terminals C and
D. There should be no continuity.
front cover (WP 0174).
Replace powershift wiring harness (WP
0167).
Proceed to Test Step 38.
Test Step 33. Test Forward Control
Circuit for a Short.
Voltage 10 to 14 Volts - Proceed to
sure voltage between powershift
step 2.
controller wiring harness connec-
No Voltage - Install instrument panel
front cover (WP 0174).
C2 and machine ground. There
should be no voltage.
Figure 186) (WP 0162).
Proceed to Test Step 38.
0051-39