TM 5-2420-231-23-2
0213
INSTALLATION CONTINUED
10. Remove bolt (Figure 32, Item 6) and washer (Figure 32, Item 7) from transmission (Figure 32, Item 1).
11. Install bracket link (Figure 32, Item 2), bolt (Figure 32, Item 6), and washer (Figure 32, Item 7) on transmission
(Figure 24, Item 1).
NOTE
Re-use hydraulic pump bolt and washer to install bracket link.
12. Install bracket link (Figure 32, Item 10), bolt (Figure 32, Item 9), and washer (Figure 32, Item 8) on
transmission (Figure 32, Item 1).
13. Attach sling and lifting device on transmission (Figure 32, Item 1).
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use
assistance during procedure. Ensure any lifting device used is in good condition and of
suitable load capacity. Keep clear of heavy parts supported only by lifting device. Failure to
follow this warning may result in injury or death to personnel.
NOTE
The transmission assembly weighs 772 lb (350 kg).
14. Using lifting device, install transmission (Figure 32, Item 1), 10 washers (Figure 32, Item 4), and bolts
(Figure 32, Item 3) on engine (Figure 32, Item 5). Tighten bolts to 38-42 lb-ft (52-57 Nm).
15. Remove sling and lifting device from transmission (Figure 32, Item 1).
16. Remove bolt (Figure 32, Item 9), washer (Figure 32, Item 8), and bracket link (Figure 32, Item 10) from
transmission (Figure 32, Item 1).
0213-30
