TM 5-3805-255-14
0005
OPERATING TECHNIQUES
0005
General
0005
Terrain, footing conditions, types of materials being worked, and maneuvering space determine the speed at which
the loader can function.
When the bucket is at work, keep the engine speed near full throttle and operate in 1st or 2nd gear transmission
range. Use 2nd and 3rd gear range for traveling purposes.
The techniques for using the loader as indicated in Figure 11 are not intended to be all inclusive. Each work
situation will vary. Loader operation may be altered for each particular application for best efficiency.
When possible, start all jobs from relatively level ground. If necessary, level an area large enough to provide
sufficient working space. This prevents back and forth pitching of the loader and will result in easier operation.
Avoid wheel spin whenever possible; this wastes effort and only converts a relatively smooth working area into ruts
and piles that pitch and tilt the loader. In cold weather, this matter can freeze and cause additional difficulty the
following day.
0005-14
