TM 5-3805-255-14
0101
HOUSING ASSEMBLY CONTINUED
3. Support housing (Figure 13, Item 1) on a press.
4. Press oil seal (Figure 13, Item 3) in flush with front face of housing (Figure 13, Item 1).
5. Place an oil seal expanding sleeve over front end of shaft assembly (Figure 13, Item 2).
6. Install shaft assembly (Figure 13, Item 2) in housing (Figure 13, Item 1), centering shaft assembly in bores.
NOTE
Press only through outer race of bearing or damage will occur.
7. Install shaft assembly (Figure 13, Item 2) in housing (Figure 13, Item 1).
Figure 13. Pressing Shaft and Bearing in Housing.
0101
0101-15