TM 5-3805-255-14
0113
ASSEMBLY CONTINUED
14. The total shim pack (Figure 13, Item 2) thickness should equal measured gap plus required additional 0.005 in.
(0.127 mm) shims or as close as possible to this dimension on plus side.
15. Remove retainer (Figure 13, Item 3) and install entire shim pack (Figure 13, Item 2). Install retainer and secure
with 12 capscrews (Figure 13, Item 5). Coat threads of each capscrew with Loctite Plastic Gasket before
installation. Tighten capscrews to a preliminary torque of 40 lb-ft (54 Nm) while rotating wheel hub (Figure 13,
Item 4).
16. Tighten 12 retainer capscrews (Figure 13, Item 5) to a final torque of 200 lb-ft (271 Nm).
17. Lubricate new seal ring (Figure 13, Item 1) with grease and install on wheel hub shoulder. Be sure there are no
twists in seal ring.
Figure 13. Final Retainer Installation.
0113
0113-11