Storage
b. Disconnect the air inlet tube from the compressor
d. Install the drain plug and a new filter element.
housing.
e. Refill the converter with the oil that is recommen-
c. Disconnect the air inlet line from the top of the
Lubrication
and
Preventive
ded
under
center housing.
Maintenance.
d. Pour approximately four ounces of lubricating oil
14. POWER TAKE-OFF
in the oil inlet opening of the center housing.
Reach in through the air inlet opening in the
Remove the inspection hole cover and inspect the
compressor housing a n d t u r n t h e r o t a t i n g
clutch release lever and link pins and the bearing ends
assembly by hand to coat the bearings, thrust ring
of the clutch release shaft. Apply engine oil sparingly,
and thrust washer with oil. Then fill the oil inlet
if necessary, to these areas.
line with engine oil.
15. HYDROSTARTER
e. Connect the oil inlet line to the top of the center
a. Open the relief valve on the side of the hand
housing. Then connect the air inlet tube to the
compressor housing.
pump and release the pressure in the system.
17. After all of
the preparations have been completed,
b . Refer to the filling and purging procedures
start the engine.
The small amount of rust preventive
outlined in Hydraulic Starting System. Then drain,
compound which
remains in the fuel system will cause
refill and purge the hydrostarter system.
a smoky exhaust
for a few minutes.
16. TURBOCHARGER
NOTE: Before subjecting the engine to a load or
high speed, it is advisable to check the engine
a. Thoroughly clean the area around the turbo-
tune-up.
charger air inlet tube and the oil inlet line.
Page 154