TM 5-3805-258-24-2
POWER TRAIN
DISASSEMBLY AND ASSEMBLY
ENGINE AND TRANSMISSION
REMOVE ENGINE AND
TRANSMISSION
1000 & 3000-11
Tools Needed
A
B
C
2V2156 Link Bracket
2
OTC 1790 Transmission Jack
1
8S9906 Ratchet Puller
1
start by:
a) remove hood*
b) remove muffler*
WARNING
If NBC exposure is suspected, all air filter media
should be handled by personnel wearing pro-
tective equipment. Consult your unit NBC Offi-
cer or NBC NCO for appropriate handling or dis-
posal instructions.
c) remove air cleaner housing*
d) remove radiator and guard*
e) remove rear drive shaft
f) remove center drive shaft
*This operation is in the ENGINE DISASSEM-
BLY AND ASSEMBLY section.
NOTE: It is not necessary to remove the transmis-
sion when just the engine is to be removed. See
ENGINE DISASSEMBLY AND ASSEMBLY.
1. Remove nuts (2) and disconnect the disconnect
switch ( 1 ) from the frame.
WARNING
To prevent personal injury, release the pres-
sure in the air reservoir before any lines are
disconnected.
NOTE: Models 950BNS and 950BS shown.
Hose locations for models 950BNSCE and
950BSCE are slightly different.
2. Disconnect air lines (3) from the engine.
3.
Put identification on wires (4), (5) and (6).
Disconnect wires (4), (5) and (6) from the
starter and the solenoid.
5-220
