ORGANIZATIONALPREVENTIVE MAINTENANCE CHECKS ANDGENERALTo make sure that your vehicle is readv forTM 5-3805-258-24-2SERVICES (PMCS)operation at all times,inspect it systematically so you can discover any defects and have’them corrected before they result in serious damage or failure.Thecharts on the next few pages contain your organizational PMCS.Theitem numbers indicate the sequence of minimum inspection requirements.If you are operating the vehicle and notice something wrong whichcould damage the equipment if you continue operation, stop operationimmediately.Record all deficiencies and shortcomings, along with the correctiveaction taken, on DA Form 2404.The Item Number column is the sourcefor the numbers used on the TM Number column on DA Form 2404.ORGANIZATIONAL PREVENTIVE MAINTENANCE CHECKS AND SERVICES (PMCS)a.The item numbers of the table indicate the sequence of thePMCS .Perform at the intervals shown below:(1)(2)(3)(4)(5)(6)b.Do your (Q) Preventive Maintenance Quarterly (every threemonths) .Do your (S) Preventive Maintenance Semiannually (everysix months) .Do your (A) Preventive Maintenance Annually (once everyyear) .Do your (B) Preventive Maintenance Biennially (once everytwo years).Do your (H) Preventive Maintenance at the hour interval1 isted.Do your (Mi) Preventive Maintenance at the mile interval1 isted.If something does not work, troubleshoot it with the.instructions in this manual or notify your supervisor.c.Always do your preventive maintenance in the same order,so it becomes a habit.Once you have had some practice, you will spotanything wrong in a hurry.---------WARNING---------Dry cleaning solvent P-D-680 is toxic and flammable.Wear protectivegoggles and gloves and use only in well ventilated areas.Avoidcontact with skin, eyes and clothes and do not breathe vapors.Do notuse near open flame or excessive heat.If you become dizzy whileusing cleaning solvent, get fresh air immediately and get medical aid.If contact with eyes is made, wash your eyes with water and getmedical aid immediately.Compressed air used for cleaning purposes will not exceed 30 psi.Useonly with effective chip guarding and personnel protection equipment(goggles/shields/gloves, etc....).J-1
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business