3. WATER TEMPERATURE SENDING UNIT DOES NOT OPERATE

6. NEUTRAL START SWITCH DOES NOT OPERATE.

TM-5-3805-262-20 Loader Scoop Type DED 4x4 Articulated Frame Steer 2-1/2 Cubic Yard (J.I. Case Model MW24C) Manual
Page Navigation
149

TM 5-3805-262-20 3-12. SENDING UNITS TROUBLESHOOTING (CONT) MALFUNCTION TEST OR INSPECTION CORRECTIVE ACTION 3. WATER TEMPERATURE SENDING UNIT DOES NOT OPERATE. Remove and test water temperature sending unit (page 5-120). a . b. If water temperature sending unit tests okay, reinstall sending unit (page 5-123) and refer to page 3-80, MALFUNCTION 11. If water temperature gage and wiring are okay, refer to page 3-53 cooling system troubleshooting. If water temperature sending unit does not test okay, replace sending unit (page 5-120). 4. CONVERTER TEMPERATURE SENDING UNIT DOES NOT OPERATE. Remove and test converter temperature sending unit (page 5-125). a . I f c o n v e r t e r t e m p e r a t u r e s e n d i n g u n i t t e s t s o k a y , r e i n s t a ll sending unit (page 5-127) and refer to page 3-79, MALFUNCTION 1. If converter temperature gage and wiring are okay, refer to page 3-101 transmission troubleshooting. b. If converter temperature sending unit does not test okay, re - place sending unit (page 5-125). 5. CLUTCH PRESSURE SWITCH DOES NOT OPERATE. Step 1. Remove engine right front side panel (page 9-14). Disconnect wire leads from terminals of clutch pressure switch by grasping with fingers and firmly pulling apart. Connect multimeter between clutch pressure switch terminals. Multimeter should indicate continuity. a . I f m u l t i m e t e r i n d i c a t e s c o n t i n u - ity, go to step 2 below. b. If multimeter does not indicate c o n t i n u i t y , r e p l a c e c l u t c h p r e s- sure switch (page 5-128). Step 2. Start engine and watch multimeter. Multimeter should indicate no continuity (open circuit). 3-94

Privacy Statement
Press Release
Contact