TM 5-3805-262-203-30. ENGINE TROUBLESHOOTING (CONT)MALFUNCTIONTEST OR INSPECTIONCORRECTIVE ACTION4. ENGINE STARTS BUT WILL NOT RUN (Cont).S t e p 8 . ( C o n t ).b . I f a i r b u b b l e s r i s i n g i n c o o l a n t a r e n o t s e e n , t e l l a s s i s t a n t toturn off engine. Install thermostats and thermostat housing(page 4-89). Connect upper radiator hose to thermostat housing(page 4-75). Fill radiator with coolant (page 4-71). Installa l t e r n a t o r d r i v e b e l t s ( p a g e 5 - 5 ) . I n s t a l l e n g i n e l e f t a n d r i g htside panels (page 9-17). Notify next higher maintenance level(engine must be checked further).5. ENGINE MISFIRES.Step 1.Open radiator grille at rear of loader.Connect STE/ICE power cable W5 connector P1 to J1 ofCheck that VTM PUSH ON/PULL OFF switch is in OFF posVTM .i t i o n .Connect power cable W5 red clip lead to loader battery positive postand black clip lead to loader battery negative post.Do STE/ICE confidence test (TM 9-4910-571-12&P).At VTM, dial 60 into TEST SELECT and press and release TEST.When UEH appears on VTM display, dial 22 into test select and pressand release TEST.Perform compression unbalance test:NOTEBe sure batteries are atunbalance tests in a rowfull charge, Don't do more than two compressionas loader batteries may discharge.3-221
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business