TM 5-3805-262-20
4-2. FUEL SYSTEM MAINTENANCE (CONT)
e. Fuel Tank (cont).
(2) Removal and Installation (cont).
INSTALLATION (SHEET
( a ) I n s t a l l
1 OF 2)
electric fuel pump (page 4-17) if necessary.
( b ) U s i n g a c h a i n h o i s t e q u i p p e d w i t h s t r a p s , p o s i t i o n f u e l t a n k ( 1 1 ) o n
r o l l e r j a c k.
(c) Move roller jack with fuel tank (11) into position beneath loader frame;
if necessary, use chain hoist to raise loader frame just enough to
enable positioning of fuel tank.
(d) Guide fuel tank (11) into position then raise into position; check that
fuel tank mounting hole located in rear of fuel tank centered on bottom
lip is aligned with hole in loader frame.
(e) Loosely install one washer (10), two washers (9), three lock washers
(8), and capscrews (7). Check that fuel tank is properly positioned; if
necessary, raise fuel tank by raising roller jack. Tighten three
capscrews (7) securely.
(f) Remove roller jack from under fuel tank .
4-36
