c. H e a t e r C o n t r o l V a l v e

INSTALLATION (SHEET 2 OF 2) - TM-5-3805-262-20_965

TM-5-3805-262-20 Loader Scoop Type DED 4x4 Articulated Frame Steer 2-1/2 Cubic Yard (J.I. Case Model MW24C) Manual
Page Navigation
946

TM 5-3805-262-20 10-6. CAB HEATER SYSTEM MAINTENANCE (CONT) c. H e a t e r C o n t r o l V a l v e . This task covers removal and installation of the HEAT CONTROL valve. TOOLS: No. 1 Common Organizational Maintenance Tool Kit Fixed open end wrench set Socket wrench set, 3/8 inch drive Screwdriver NOTE PRELIMINARY PROCEDURE: Engine side panels removed (page 9-14), heater w a t e r s h u t - o f f v a l v e s c l o s e d a t w a t e r p u m p a n d e n g i n e b l o c k , b a t t e ry ground cable disconnected (page 5-148), a n d o p e r a t o r ’ s s e a t u p p e r s e at support removed from cab (page 9-31). REMOVAL (SHEET 1 OF 2) (1) ( 2) (3) (4) At cab switch panel, remove HEAT CONTROL knob (1) by pulling straight up o f f c o n t r o l s h a f t. Remove four screws (2). Carefully pull cab switch panel (3) Up from heater console just enough to gain access to HEAT CONTROL valve ports and its mounting hardware. At HEAT CONTROL valve, loosen clamp (4) and disconnect hose (5) from valve by pulling it from valve port. 10-46

Privacy Statement
Press Release
Contact