TM 5-3805-290-23-2
PARKING BRAKE MAINTENANCE - CONTINUED
0092 00
CLEANING AND INSPECTION
WARN I N G
Solvent cleaning compound MIL-PRF-680 Type III is an environmentally compliant and low-toxic material.
However, it may be irritating to the eyes and skin. Use protective gloves and goggles. Use in well-ventilated
areas. Keep away from open flames and other sources of ignition. Failure to do so may result in injury or
death to personnel.
Particles blown by compressed air are hazardous. DO NOT exceed 15 psi (103 kPa) nozzle pressure when dry-
ing parts with compressed air. DO NOT direct compressed air against human skin. Make sure air stream is
directed away from user and other personnel in the area. To prevent injury, user must wear protective goggles
or face shield. Failure to follow this warning may result in injury to personnel.
1.
Clean all parts and surfaces with solvent cleaning compound.
2.
Dry parts with compressed air.
3.
Inspect all parts for wear, pitting, cracks, or corrosion and replace if necessary.
INSTALLATION
WARN I N G
Spring is under tension. Wear eye protection and use extreme caution when removing spring to avoid
injury to personnel.
1.
Position bracket (50) on machine and install three washers (49) and bolts (48) on bracket.
2.
Install parking brake cable (33) on clevis (46) and tighten nut (47) on parking brake cable.
3.
Install clevis pin (45) on clevis (46).
N OT E
Do not fully set cotter pin until brake cable adjustment is made. See Adjustment in this work package.
4.
Install new cotter pin (44) on clevis pin (45).
5.
Install clip (43) on parking brake cable (33).
6.
Install three clips (42) on parking brake cable (33).
7.
Install three washers (41) and bolts (40) on machine.
0092 00-6
